氧化硫醚:Oxone氧化的OPRD案例汇总
案例一化合物7的合成乙烯硫醚6产品不分离,Oxone氧化后,重结晶可去除大部分杂质。主要杂质是过度氧化杂质16。实验操作To the concentrated solution from the previous step, 2-MeTHF (800 L) and 2-propanol (800 L) were added sequentially under a nitrogen atmosphere. The solution was cooled to −5 °C. An aqueous solution of Oxone [prepared by dissolving Oxone (300 kg, 5.3 equiv wrt 6-iodotetralone 4) in water (1450 L)] was added slowly to the reaction mixture while maintaining the temperature between−5 and 0 °C. The reaction mixture was warmed to 25 °C and stirred for 20 h.After completion of the reaction, the reaction mixture was filtered through a Nutsche filter using a 5 μm cloth. The reactor was rinsed using additional EtOAc (250 L), and the rinse used to wash the filter cake. The combined filtrate was charged back into the reactor followed by EtOAc (500 L), and the resulting biphasic mixture was stirred for 15 min. The layers were separated and the organic layer was washed with a 10% aqueous sodium sulfite solution (3 × 800 L).参考文献10.1021/acs.oprd.1c00125案例二实验操作Hydrogensulfate salt 6a (4.0 kg; 9.4 mol) was suspended in ethyl acetate (40 L),and the mixture was stirred vigorously while a solution of Oxone (5.78 kg; 9.4 mol) in water (29 L) was added.The resulting biphasic mixture was stirred vigorously for 90 min, and then a solution of Oxone (5.78 kg; 9.4 mol) in water (29L) was added. The mixture was then stirred for a further 2 h, and then a third charge of Oxone (5.78 kg; 9.4 mol) in water (29 L) was added.After a further 6 h stirring, analysis showed incomplete conversion (25% of the intermediate sulfoxide 11 present). A solution of Oxone (5.78 kg; 9.4 mol) in water (29L) was added, and the mixture was stirred for 6 h.Analysis at this point still showed incomplete conversion (4% sulfoxide 11), so a further portion of Oxone (5.78 kg; 9.4 mol) in water(29 L) was added, and the resulting mixture was stirred for 14.5 h. The phases were separated, and the aqueous phase was extracted with ethyl acetate (36 kg).The combined organic phase was washed with water (40 L) and filtered through a 1.2μm filter, and then the solution was concentrated to ∼20 L by distillation. Isopropanol (31.4 kg) was added, and the solution was again concentrated to ∼20 L by distillation. Isopropanol (31.4 kg) was added, and the solution was concentrated to 34 L by distillation. The solution was then cooled to 20 °C over 2 h, and the resulting slurry was aged at 20 °C for 6 h before the solid was isolated by filtration, washing with isopropanol (2 × 15.7 kg). The solid was then dried at 55 °C under vacuum for 8 h to give the product 8 (2.54 kg; 75%) as a white solid.参考文献Organic Process Research & Development 2009, 13, 848–853案例三实验操作The residue 7 was dissolved in acetone (53.75 kg) and THF (151.10 kg), and a 23.4% aq oxone (531.00 kg; 404.2 mol) was added to it dropwise over a period of 3.5 h at 15−25 °C. After stirring for 2h, EtOAc (245.00 kg) was added to the resulting mixture. The resulting suspension was filtered by centrifuge, and the filter cake was washed with EtOAc (61.80 kg).The filtrate was transferred to a reactor, and 9.5% aq Na2S2O3 (143.30 kg) was added to it over a period of 45 min at 15−30 °C, and the resulting mixture was stirred for 40 min. [The procedure on a pilot scale was not optimized.Our optimized procedure is as follows: The filtrate was transferred to a reactor, and 9.5% aq NaHSO3 was added to it at 15−30 °C, and the resulting mixture was stirred for 0.5−1 h.] After settling for 35 min, the aqueous layer was separated, and extracted with EtOAc (122.10kg). The organic layers were collected, washed with a 10% aq Na2CO3 (135.50 kg) and 10% aq NaCl (135.50 kg), and concentrated under vacuum at 35−45 °C until no further distillate could be collected.参考文献dx.doi.org/10.1021/op400354g 案例四In a 1.0 L jacketed reactor, equipped with an overhead stirrer, was charged 138 g (0.228 mol) of Oxone and 500 mL of water. The mixture ws stirred vigorously to complete dissolution with the temperature maintained at 25 °C. The solution of 4 obtained in the preparation described above was then added.For the 400 mL acetonitrile solution a quantitative yield was assumed, corresponding to 26.4 g (0.091 mol) of 4. The mixture was heated to 40 °C for 7 h 30 min; the heating system was switched off and left to react overnight at room temperature. After an overall 24 h, the mixture was concentrated by evaporation of acetonitrile at reduced pressure.参考文献Organic Process Research & Development 2009, 13, 456–462案例五(a) oxone, water, THF, r.t., 16 h, 95%.参考文献https://doi.org/10.1021/acs.oprd.4c00211